Cisco 7940 - Manual (Page 5)

91-5
Cisco Unified Communications Manager Administration Guide
OL-14495-01
Chapter 91 IP Phone Services Configuration
Configuring an IP Phone Service Parameter
Procedure
Step 1 Find the IP phone service by using the procedure in the “Finding an IP Phone Service” section on
page 91-1 .
Step 2 Click the name of the IP phone service that you want to delete.
The IP phone services Configuration window displays.
Step 3 Click Delete.
You receive a message that asks you to confirm the deletion.
Step 4 Click OK.
The window refreshes, and the IP phone service gets deleted from the database.
Additional Information
See the “Related Topics” section on page 91-8 .
Configuring an IP Phone Service Parameter
Use the following procedure to add and configure or update IP phone service parameters. Add the phone
service before you configure parameters. Refer to the documentation for the individual IP phone service
for specific information about whether the service uses parameters, how those parameters should be
configured, and whether you should provide optional parameter definitions.
Procedure
Step 1 Find the IP phone service by using the procedure in the “Finding an IP Phone Service” section on
page 91-1 .
Step 2 From the IP phone services list, choose the service to which you want to add parameters or update
existing parameters.
The IP phone services Configuration window displays.
Step 3 Perform one of the followings tasks:
• To add a new phone service parameter, click the New button to the right of the Parameters list box.
The Configure IP phone service Parameter window displays. Continue with
Step 4 .
• To update an existing parameter, choose the name of the parameter that you want to update in the
Parameters list box. Click Edit and continue with
Step 4 .
Step 4 Enter the appropriate settings as described in Table 91-2 .
To add the new parameter, click Save. To add additional parameters, if needed, click Add New in the
Configure IP phone service Parameter window and repeat
Step 3 and Step 4 .To add the last parameter,
click Save and Close.
To apply the changes to the updated parameters, click Save, or to apply the changes and close the
window, click Save and Close.