Dell PowerVault DR2000v - Manual (Page 21)

21 Setting up NetVault SmartDisk on the Dell™ DR4X00 Disk Backup Appliance
4 Configure NetVault SmartDisk
NOTE: This Chapter assumes that the user has already created the needed CIFS, NFS, CIFS/NFS container
and assigned the desired permission(s) as detailed in the Install and Configure the DR4X00 chapter.
4.1 Windows
The steps in this section will require access to the NetVault SmartDisk server and the NetVault NetBackup
Server.
1. From a command prompt on the SmartDisk server, cd to the \NetVault
SmartDisk\Foundation\bin folder.
2. Run the command smartdisk.bat config –show to view the current configuration.
3. Run the following command to disable deduplication for the SmartDisk configuration:
smartdisk.bat config –dedupe-enable FALSE
4. Verify that the value has been set to false by using the command: smartdisk.bat config –show