Dell PowerVault 725N (Rackmount NAS Appliance) - Manual (Page 14)

intranet network using an internet browser. Some systems provide for attaching a keyboard, mouse, and monitor for specific management or service needs,
others do not.
host adapter
A host adapter implements communication between the system's bus and the controller for a peripheral device. (Hard drive controller subsystems include
integrated host adapter circuitry.) To add a SCSI expansion bus to your system, you must install or connect the appropriate host adapter.
Hz
Abbreviation for hertz.
IDE
Abbreviation for integrated drive electronics
I/O
Abbreviation for input/output. A keyboard is an input device, and a printer is an output device. In general, I/O activity can be differentiated from computational
activity. For example, when a program sends a document to the printer, it is engaging in output activity; when the program sorts a list of terms, it is engaging
in computational activity.
ID
Abbreviation for identification.
interlacing
A technique for increasing video resolution by only up-dating alternate horizontal lines on the screen. Because interlacing can result in noticeable screen
flicker, most users prefer noninterlaced video adapter resolutions.
internal microprocessor cache
An instruction and data cache built in to the microprocessor. The Intel® Pentium® microprocessor includes a 16-KB internal cache, which is set up as an 8-KB
read-only instruction cache and an 8-KB read/write data cache.
IP
Abbreviation for Internet Protocol.
IPX
Abbreviation for Internetwork Packet EXchange.
IRQ
Abbreviation for interrupt request. A signal that data is about to be sent to or received by a peripheral device travels by an IRQ line to the microprocessor.
Each peripheral connection must be assigned an IRQ number. For example, the first serial port in your system (COM1) is assigned to IRQ4 by default. Two
devices can share the same IRQ assignment, but you cannot operate both devices simultaneously.
ITE
Abbreviation for information technology equipment.
jumper
Jumpers are small blocks on a circuit board with two or more pins emerging from them. Plastic plugs containing a wire fit down over the pins. The wire connects
the pins and creates a circuit. Jumpers provide a simple and reversible method of changing the circuitry in a printed circuit board.
K
Abbreviation for kilo-, indicating 1,000.
KB
Abbreviation for kilobyte(s), 1,024 bytes.
KB/sec
Abbreviation for kilobyte(s) per second.
Kbit(s)
Abbreviation for kilobit(s), 1,024 bits.
Kbit(s)/sec
Abbreviation for kilobit(s) per second.
key combination
A command requiring you to press multiple keys at the same time. For example, you can reboot your system by pressing the <Ctrl><Alt><Del> key
combination.