Dell Latitude XT2 XFR (Late 2009) - Manual (Page 80)

Dell ™ Latitude™ XT2 XFR Service Manual
Page 80 of 94 Version A00-01
6.2.3 IEEE 1394 Device Problems
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
NOTE: Your computer supports only IEEE 1394a standard.
ENSURE THAT THE CABLE FOR THE IEEE 1394 DEVICE IS PROPERLY INSERTED INTO
THE DEVICE AND INTO THE CONNECTOR ON THE COMPUTER
ENSURE THAT THE IEEE 1394 DEVICE IS ENABLED IN SYSTEM SETUP — For more information
on using the system setup program, see the Dell™ Technology Guide on your computer or at
support.dell.com.
ENSURE THAT THE IEEE 1394 DEVICE IS RECOGNIZED BY WINDOWS —
Windows XP:
5. Click Start and click Control Panel.
6. Under Pick a Category, click Performance and Maintenance
→ System→ System
Properties → Hardware→ Device Manager.
Windows Vista:
Click Start → Control Panel→ Hardware and Sound.
Click Device Manager. If your IEEE 1394 device is listed, Windows recognizes the device.
IF YOU HAVE PROBLEMS WITH A DELL IEEE 1394 DEVICE — Contact Dell Support.
IF YOU HAVE PROBLEMS WITH AN IEEE 1394 DEVICE NOT PROVIDED BY DELL — Contact the
IEEE 1394 device manufacturer.
6.2.4 Lockups and Software Problems
CAUTION: Before you begin any of the procedures in this section, follow the safety
instructions that shipped with your computer.
The Computer Does Not Start Up
CHECK THE DIAGNOSTIC LIGHTS — See
Power Problems .
ENSURE THAT THE POWER CABLE IS FIRMLY CONNECTED TO THE COMPUTER AND TO THE
ELECTRICAL OUTLET
The computer stops responding
NOTICE: You may lose data if you are unable to perform an operating system shutdown.
TURN THE COMPUTER OFF — If you are unable to get a response by pressing a key on your
keyboard or moving your mouse, press and hold the power button for at least 8 to 10 seconds (until
the computer turns off), and then restart your computer.
A Program Stops Responding
END THE PROGRAM —
1. Press <Ctrl><Shift><Esc> simultaneously to access the Task Manager.
2. Click the Applications tab.
3. Click to select the program that is no longer responding.
4. Click End Task.