Dell 1609WX Projector - Manual (Page 32)

32 Using Your Projector
LAMP
Using the Lamp menu, you can adjust the display settings of your projectors. The
Picture menu, provides the following options:
L
AMP
H
OUR
—Displays the operating hours since the last lamp timer reset.
P
OWER
S
AVING
—Select Yes to set the Power Saving delay period. The delay period is
the time you want the projector to wait without an input signal. By default, the
delay period is set to 120 minutes. However, you can set this to 5, 15, 30, 45, 60, or
120 minutes.
If an input signal is not detected during the delay period, the projector turns off
the lamp and goes into power saving mode. If an input signal is detected when
projector is in power saving mode, the projector automatically turns on. If an input
signal is not detected within two hours, the projector switches from Power Saving
mode to Power Off mode. To turn on the projector press the Power button.
E
CO
M
ODE
—Select On to use the projector at a lower power level (216 Watts),
which may provide longer lamp life, quieter operation, and dimmer luminance
output on the screen. Select Off to operate at normal power level (256 Watts).
L
AMP
R
ESET
—After you install a new lamp, select Yes to reset the lamp timer.
Q
UICK
S
HUTDOWN
—Select Yes to turn off the projector with a single press of the
Power button. This function allows the projector to quick power off with an
accelerated fan speed.
NOTE: If Quick Shutdown is enabled, expect a slightly higher acoustic noise
during power off.