Dell PowerVault DL2200 CommVault - Manual (Page 7)

Configuring a Dell™ EqualLogic™ PS Series Array as a Backup Target for CommVault™ Simpana™
Page 5
Configuring iSCSI settings on the DL Backup to Disk appliance
 Launch the EqualLogic Host Integration Toolkit (HIT Kit) on the DL Backup to Disk appliance and
select the Custom Installation option.
 At the “Select Components” section, select the Remote Setup Wizard and the MultiPath I/O
DSM components. The Volume Shadow Copy Service Provider, ASM/ME Command Line
Interface, Auto-Snapshot Manager and the Virtual Disk Service (VDS) provider components are
not required when configuring the EqualLogic PS Series Array as a backup target. Refer to
Figure 2.
o
If the iSCSI initiator service is not running, the HIT Kit will prompt the user to start the
service and enable iSCSI traffic through the firewall or request permission to do so
automatically.
o
If not already configured, the MPIO component of the HIT Kit will prompt the user to
configure the firewall to allow echo requests (pings) or request permission to do so
automatically.
o
If not already installed, the HIT Kit will prompt the user to install the Microsoft
Multipath I/O feature or request permission to do so automatically.
o
Once the HIT Kit components are installed, a reboot of the DL Backup to Disk Appliance
is required.
Figure 2: Installing the Host Integration Toolkit (HIT Kit) components