Screw identification and tightening, Screw identification and tightening -2, Crew identification and tightening – Dell Latitude LM User Manual
Page 38
Advertising
4-2
Dell Latitude LM Systems Service Manual
•
Small scribe (or Delrin [plastic] screwdriver)
•
Nut drivers
•
Chip removal tool
S
crew Identification and Tightening
.
Figure 4-2. Screw Identification
Where applicable, information about screw lengths is provided in illustrations.
Before installing a screw, match the screw to the screw length graphics provided
to check for correct length.
CAUTION: It is essential that the correct length screw be used when
reinstalling a screw. Otherwise, hardware damage could result. Make
sure that the screw is properly aligned with its corresponding hole, and
avoid overtightening.
B7
(screw B7 is 3 mm)
3 mm
Advertising