Camera, Removing the camera – Dell Inspiron 14 (N4030, Mid 2010) User Manual
Page 10
Back to Contents Page
Camera
Dell™ Inspiron™ N4020/N4030 Service Manual
Removing the Camera
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Follow the instructions from
step 3
to
step 4
in
Removing the Hard Drive
.
4.
Follow the instructions from
step 3
to
step 5
in
Removing the Optical Drive
.
5.
Remove the module cover (see
Removing the Module Cover
).
6.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
7.
Remove the keyboard (see
Removing the Keyboard
).
8.
Remove the palm rest (see
Removing the Palm Rest
).
9.
Remove the display assembly (see
Removing the Display Assembly
).
10.
Remove the display bezel (see
Removing the Display Bezel
).
11.
Disconnect the camera cable from the connector on the camera module.
12.
Slide and lift the camera module to remove it from the tabs on the display cover.
13.
Lift the camera module out of the display cover.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 camera module
2 tabs (2)
3 display cover
4 camera cable connector