Installing the input/output (i/o) panel, Removing the system board – Dell Precision T1650 (Mid 2012) User Manual
Page 29
Advertising
Figure 23.
Installing the Input/Output (I/O) Panel
1.
Insert the I/O panel into the slot on the chassis front.
2.
Slide the I/O panel towards the right of the computer to secure to the chassis.
3.
Tighten the screw to secure the I/O panel to the chassis.
4.
Thread the I/O panel/FlyWire cable into the chassis clip.
5.
Connect the I/O panel/FlyWire cable to the system board.
6.
Install the:
a) front panel
b) cover
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a) cover
b) front panel
c) expansion card(s)
d) heat sink
e) processor
3.
Disconnect all the cables connected to the system board.
29
Advertising