Dell PowerEdge VRTX - Manual (Page 5)

Connecting The CMC Module
Figure 4. Connecting the CMC Module
Connect the serial cable (optional) and network cable(s) from the management system to the CMC module.
NOTE: Your system comes with the CMC installed in slot 1.
NOTE: If the second CMC (optional) is not installed, connect the network cable to CMC port 1 on the enclosure.
NOTE: The serial port connects to the active CMC module.
Connecting The I/O Module
Figure 5. Connecting the I/O Module
Connect the network cable to the I/O module to provide network connection to the server.
NOTE: If you have a pass-through module installed in the enclosure, each server module requires its own network
cable.
NOTE: For information on configuring the network settings for the I/O module, see the Dell Chassis Management
Controller for Dell PowerEdge VRTX User’s Guide at dell.com/esmmanuals.
5