Dell PowerVault 210S (SCSI) - Manual (Page 26)

1-12 Dell PowerVault 200S and 210S Storage Systems Rack Installation Guide
"  
 
 
   
#  
! 

"   
    
To replace the 24-U rack’s front and back doors, perform the following steps:
1. Lift the front door into position and align the hinges with the hinge insert in the
rack as shown in Figure 1-4.
2. Slide the hinge pins into the hinge insert in the rack until the hinges lock into
position.
3. Verify that the hinges are latched.
4. Close the door latch by rotating the handle counterclockwise until it stops (see
Figure 1-2).
5. Repeat steps 1 through 4 to replace the back door.
To replace the 42-U rack’s front and back doors, perform the following steps:
1. Lift the front door into position and align the hinges with the holes in the rack as
shown in Figure 1-5.
2. Slide the hinges into the holes in the rack until the hinge release levers lock the
hinges into position.
3. Verify that the hinges are latched.
4. Close the door latch by rotating the handle counterclockwise until it stops, push
in the handle until it locks in position, and slide the cover down over the push but-
ton (see Figure 1-3).
5. Repeat steps 1 through 4 to replace the back door.