Dell Latitude D610 - Manual (Page 39)

Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Latitude™ D610 Service Manual
Removing the Microprocessor Thermal-Cooling Assembly
Installing the Microprocessor Thermal-Cooling Assembly
Removing the Microprocessor Thermal-Cooling Assembly
1. Follow the instructions in " Preparing to Work Inside the Computer ."
2. Remove the center control cover (see " Removing the Center Control Cover ").
3. Remove the keyboard (see " Removing the Keyboard ").
4. Remove the display assembly (see " Removing the Display Assembly ").
5. Remove the palm rest (see " Removing the Palm Rest ").
6. Loosen in consecutive order the three captive screws, labeled "1" through "3," that secure the microprocessor thermal-cooling assembly to the system
board.
7. Lift to remove the microprocessor thermal-cooling assembly away from the system board.
Installing the Microprocessor Thermal-Cooling Assembly
1. Place the microprocessor thermal-cooling assembly on the system board.
2. Tighten the three captive screws, labeled "1" through "3," in consecutive order.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
NOTE: You can remove the microprocessor thermal-cooling assembly with the fan attached.
1 microprocessor thermal-cooling assembly
2 captive screws (3)