Vermont Casting NVBR36 - Manual (Page 12)

12
NVB Series B-Vent Gas Fireplace
7412950
Operating Instructions
Glass Information
Only glass approved for use in Majestic
Fireplaces products may be used for re-
placement.
• Glass doors are optional. The appliance may be
operated safely without glass doors.
• The use of any non-approved replacement glass will
void all product warranties.
• Bi-fold glass doors MUST BE completely open or
closed while the appliance is in operation.
• Care must be taken to avoid breakage of the glass.
• Under no circumstances should this appliance be
operated with broken glass. Replacement of the
glass as supplied by the manufacturer should be
completed by a licensed qualified service person.
• Replacement glass is available through your
Majestic Fireplaces dealer and should only be
installed by a licensed qualified service person.
Glass Cleaning
It will be necessary to clean the glass periodically.
During start-up, condensation, which is normal, forms
on the inside of the glass and causes lint, dust and
other airborne particles to cling to the glass surface.
Also, initial paint curing may deposit a slight film on
the glass. It is therefore recommended that the glass
be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend
gas fireplace glass cleaner). After that the glass should
be cleaned two or three times during each heating
season depending on the circumstances present.
Clean glass after first two weeks of
operation.
Log Installation
1. Open glass door (if installed).
2. Remove logs from the packaging.
As with all plastic, these bags
are not toys and should always
be kept away from children and
infants.
3. Place left rear log on rear log support.
Ensure that log is firmly positioned and
there is no side-to-side movement. (Figs.
15 & 16)
4. Carefully place Ember Left and Right Logs
between grate and burner. (Figs. 15 & 16)
5. Place the front of right rear log on the
burner and the back of the log on the rear
log support.
6. Place the top logs onto the locator notch-
es. Ensure the logs are secure. (Fig. 15 &
16)
Ember Material Placement
Separate the ember material into small
pieces, roughly 1/2" in diameter and place
on bracket over front burner tube. Do not
pack down; leave in loose, fluffy condition for
most realistic ember effect. (Fig. 15 & 16)
Lava Rock
The lava rock provided with this fireplace
must be placed on the firebox base on either
side of the burner assembly.
LG149
NVB36
logs
2/1/01 djt
Right Cross
Log
Left
Cross
Log
Left Rear
Log
Right Rear
Log
Embers
Ember
Right
Log
(Short)
Lava Rock
Lava Rock
Ember Left
Log (Long)
LG149
Fig. 15 NVB36 log placement.