Installing the rack kit, Remove the rack’s front and back doors, Install the slide assemblies in the rack – Dell PowerVault 51F (8P Fibre Channel Switch) User Manual
Page 17: Removing the doors from a 24-u or 42-u rack, Open the latch on the front door, Figure 2, Opening the 24-u rack cabinet front door latch
support.dell.com
Dell PowerVault 56F Systems Rack Installation Guide
3
" $
NOTE: For instructions on installing the PowerVault switch itself, see”Installing the
Switch in the Rack” found later in this guide.
To install the rack kit in the rack, perform the following steps:
1.
Remove the rack’s front and back doors.
2.
Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
& ) *+ , +* ,
You must remove the doors from the rack to provide access to the interior of the rack
and to prevent damage to the doors while installing the switch. To remove the doors,
perform the following steps.
# !
"
1.
Open the latch on the front door.
If you have a 24-U (1 U=1.75 inches) rack cabinet, unlock and twist the handle
clockwise and open the door (see Figure 2).
886nceb0.book Page 3 Friday, April 14, 2000 9:37 AM