Display assembly, Removing the display assembly – Dell Studio XPS M1640 (Mid 2010) User Manual
Page 20
Back to Contents Page
Display Assembly
Dell™ Studio XPS™ 1640 Service Manual
Replacing the Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the palm rest (see
Removing the Palm Rest
).
3.
Remove the optical drive (see
Removing the Optical Drive
).
4.
Make note of the Mini-Card cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
5.
Remove the two screws from the computer base.
6.
Turn the computer over.
7.
Pull the Mini-Card cables out through the system board so that they are clear of the computer base.
8.
Make note of the display cable, camera cable, and power/battery light cable routing and carefully dislodge the cables from their routing guides.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not
covered by your warranty.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTICE:
To avoid damage to the display, you must not disassemble your Edge-to-Edge display assembly in the field.