Chariot Carriers CX 1 - Manual (Page 48)

48
Now secure the drawbars by inserting the security pin from
above through the vertical hole in the arm and VersaWing 2.0
until it stops. Lock the security pin by looping the spring clip
over the pins end that protrudes underneath the VersaWing 2.0.
DANGER
Always make sure that the security pins of the drawbars are
properly inserted to prevent the carrier from accidentally
running away. You run the risk of an accident!
TIP
The holes in the drawbars are larger than the security pins,
so that the arms can rotate slightly around their longitudinal
axes (in order to adapt to narrow or wide hips, and single and
double width carriers).
Length adjustment of the drawbars
The drawbars are adjustable for length. To do this, withdraw the
security pin which connects the two drawbar tubes.
Move both tubes towards each other until the desired holes in
both tubes align with each other.
Reinsert the security pin, pushing it in until it goes no
further.
DANGER
Always make sure that the security pins which connect both
tubes of the drawbar are properly inserted in to prevent the
carrier from accidentally running away. You run the risk of an
accident!
Putting on the waist belt
Always put the waist belt on so that the padded area is at the
back and the strap with its side-release buckle is at the front.
Always close the buckle with care!
Adjust the 2 straps on either side of the buckle to that it is a tight
¿WDURXQG\RXUKLSVDQGVRWKDWWKHEXFNOHLVFHQWHUHG
DANGER
Always make sure the buckle on the strap is securely closed
DQGWKHVWUDS¿WVWLJKWO\,IWKLVLVQRWGRQHWKH&DUULHUPLJKW
get separated from you and run away. You run the risk of an
accident!
If required, the waist belt can be adjusted for larger and smaller
hips. To do this, undo both attachment screws and reinstall
WKHPLQWRWKHDSSURSULDWHJURPPHWV:KHQUH¿WWLQJWKHVFUHZV
always use the additional self-locking nuts supplied.
DANGER
Once self-locking nuts have been loosened they cannot be
reused. Once they have been loosened, they lose their se-
curing function, and this can lead to unexpected loosening of
the screw connection with potentially serious consequences.