Dell Latitude L400 - Manual (Page 4)

6. Click Properties.
7. Click the Driver tab.
8. Click Update Driver.
The Update Device Driver Wizard window appears.
9. Select Specify the location of the driver (Advanced).
10. Click Next.
11. Click to uncheck Removable Media, and click to check Specify a location.
12. Type your CD drive designator (for example, d:\) and then click Browse .
13. Navigate to the Network subdirectory, double-click the Network subdirectory, double-click the R21083 folder, and click OK.
14. At the Update Device Driver dialog box, click Next.
15. Verify that 3Com 3C920 Integrated Fast Ethernet Controller (3C905C-TX Compatible) is selected, and then click Next.
16. When the Update Device Driver Wizard verifies the location of the driver, click Next.
17. To verify and accept the name of the driver, click Next.
18. When you receive the message that the software installation is complete, click Finish.
19. When prompted to restart your system, remove the operating system CD and click Yes.
Installing the NIC Driver for Windows NT
1. Save your work and insert your ResourceCD. You may close the CD interface (if desired) before continuing with the procedure.
2. Double-click the My Computer icon, double-click Control Panel, and then double-click the Network icon.
3. At the Network Configuration dialog box, click Yes to install Windows NT Networking.
4. At the Network Selection dialog box, click Next to accept Wired to Network (the default).
5. Click Start Search.
6. Click Select from list.
7. Click Have Disk.
8. Use Windows NT Explorer to identify the path to the network driver on the ResourceCD (for example, d:\network\R21083).
9. Close Windows NT Explorer and type the path in the space provided, and then click OK.
10. At the Select OEM Option dialog box, click OK to accept 3Com Etherlink PCI NIC.
11. Click Next.
12. To accept TCP/IP protocol, click Next.
13. Select your desired network services and click Next.
14. When you see the message that Windows NT is ready to install the software, click Next.
15. At the Windows NT Setup dialog box, insert your Windows NT CD, type d:\I386 (where d: is your drive designator) and click Continue.
16. Follow the instructions to configure your network.
17. At the message that the installation of Networking is complete, click Finish.
18. Click Yes to restart the computer.
NOTES: To use the Dell Latitude L400 ResourceCD with Windows NT, you must have Internet Explorer 4.x installed on your computer.
Because Windows NT is shipped with Internet Explorer 3.x installed, you must install IE4.x before attempting to install drivers from the
ResourceCD. An Internet Explorer 4.0 installation CD is shipped with your system.
The following procedure assumes that you are configuring your system to access a network through the computer's built-in NIC using
TCP/IP protocol. For other network configurations, refer to your Windows NT documentation.