Dell KVM 180AS - Manual (Page 15)

Installation 15
3
Line up the screw holes in the bracket with the screw holes in the switch.
4
With a Phillips screwdriver, fasten the front mounting brackets to the switch using two
screws on each side.
5
Attach four cage nuts or clip nuts to the rack mounting flange of the rack cabinet’s front so
that the nut is positioned on the inside of the rack.
6
Mount the switch assembly to the rack cabinet by matching the holes in the “short side” of
each bracket to an appropriate set of matching holes on your rack cabinet. Next, insert the
combination hex head screws through the slots in the bracket, then the holes in the
mounting rail, and then into the cage nuts or clip nuts.
7
Attach four cage nuts or clip nuts to the rack mounting flange of the rack cabinet back so
that the nut is positioned on the inside of the rack.
8
Slide the rear brackets into the channel of the front brackets adjusting them to fit the rack
depth.
9
Mount the rear bracket to the rack cabinet by matching the holes in the “short side” of
each bracket to an appropriate set of matching holes on your rack cabinet, ensuring the
switch is level within the rack.
10
Insert the combination hex head screws through the slots in the bracket and the holes in the
mounting rail, then into the cage nuts or clip nuts.