Dell S510 Interactive Projector - Manual (Page 8)

pdmAlertSeverity = other (1)
The reset Object will respond default.
b) If there is FAN alert happen, the tables is shown below.
pdmAlertGroupType =” Fan”
pdmAlertGroupID = “Fan Error”
pdmAlertSeverity = Critical (3)
The rest Object will respond default.
c) If there is Lamp fail alert happen, the tables is shown below.
pdmAlertGroupType = “Lamp”
pdmAlertGroupID= Lamp Fail
pdmAlertSeverity = Critical (3)
The rest Object will respond default.
d) If there is Lamp hours running out alert happen, the tables is shown below.
pdmAlertGroupType = “Lamp”
pdmAlertGroupID= Lamp hours running out
pdmAlertSeverity = warning (4)
The rest Object will respond default.
e) If there is Projector Over-heating alert, the tables is shown below.
pdmAlertGroupType = “ThermalSensor”
pdmAlertGroupID= “Projector Overheating”
pdmAlertSeverity = warning (4)
The rest Object will respond default.
Note 2:
1. Other
2. Unknown
3. VGA
4. DVI-D
5. DVI-I
6. HDMI
7. Component Video BNC-5
8. Component Video BNC-3
9. DisplayPort
10. S-Video
11. RJ45
12. Wireless
13. RCA Plug Video-3
14. RCA Plug Audio
15. Mini jack 2 dot 5mm Audio
16. Mini jack 3 dot 5mm Audio
17. Coax Audio
18. Fibre Audio
19. Memory Card
20. USB Memory
21. USB Display
22. Intel® WiDi
23. Internal Memory
Information in this document is subject to change without notice.
© 2014 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly
forbidden.
Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks
and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its
own.
December 2014 Rev. A00