Dell Inspiron 13z (N311z, Mid 2011) - Manual (Page 44)

44 Display
Replacing the Display Assembly
1 Follow the instructions in "Before You Begin" on page 9.
2 Place the display assembly in position and replace the two screws (one on
each side) that secure the display assembly to the computer base.
3 Route the Mini-Card antenna cables and the display cable through the slot
on the computer base.
4 Connect the display cable to the connector on the system board.
5 Replace the wireless card antenna cables. See "Replacing the Mini-Card"
on page 36.
6 Replace the hinge cover. See "Replacing the Hinge Cover" on page 41.
7 Replace the palm-rest assembly. See "Replacing the Palm-Rest Assembly"
on page 32.
8 Replace the keyboard. See "Replacing the Keyboard" on page 27.
9 Turn the computer over.
10 Replace the two screws that secure the display assembly to the computer
base.
11 Replace the module cover. See "Replacing the Module Cover" on page 16.
12 Replace the battery. See "Replacing the Battery" on page 14.
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
Display Bezel
Removing the Display Bezel
CAUTION: The display bezel is extremely fragile. Be careful when removing it to
prevent damaging the bezel.
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the display assembly. See "Removing the Display Assembly" on
page 42.
3 Using your fingertips, carefully pry up the inside edges of the display bezel.
4 Remove the display bezel.