Two-post rack installation tasks, Marking the rack, Figure 1-1 – Dell PowerEdge 2650 User Manual
Page 8: Two-post rack kit components
1-4
2-Post Rack Installation
www
.dell.com | support.dell.com
• +Twelve 12-24 x 0.5-inch pan-head Phillips screws
• Tie-wraps (not shown in Figure 1-1)
F i g u r e 1 - 1 .
Tw o - P o s t R a c k K i t C o m p o n e n t s
Two-Post Rack Installation Tasks
Installing a two-post rack kit includes performing the following tasks in their numbered
order:
1
Marking the rack
2
Installing the slide assemblies in the rack:
• Center-mount installation
• Flush-mount installation
3
Installing the system in the rack
4
Installing the cable-management arm
5
Routing cables
Marking the Rack
You must allow 2 U (88 mm, or 3.5 inches) of vertical space for each system you install in
the two-post rack.
slide assemblies (2)
cable-management arm
status indicator cable
stiffening bracket
12-24 x 0.5-inch
pan-head
Phillips screw (12)