Dell Latitude D830 (Early 2007) - Manual (Page 29)

Back to Contents Page
Keyboard
Dell™ Latitude™ D830 Service Manual
1. Follow the procedures in Before You Begin .
2. Remove the hinge cover (see Hinge Cover ).
3. Remove the three M2 x 3-mm screws at the top of the keyboard.
4. Rotate the keyboard forward and lay it on the palm rest to allow access to the keyboard connector on the system board.
5. Pull up on the pull-tab to disconnect the keyboard cable connector from the keyboard connector on the system board.
6. To replace the keyboard, connect the keyboard cable connector to the keyboard connector on the system board.
7. Place the tabs along the front edge of the keyboard into the palm rest and lay the keyboard down on the palm rest.
8. Replace the three M2 x 3-mm screws at the top of the keyboard.
9. Replace the hinge cover (see Hinge Cover ).
Back to Contents Page
CAUTION: Before working inside your Dell™ computer, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back
panel of the computer.
NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the
keyboard.
1 keyboard 2 M2 x 3-mm screws (3) 3 keyboard cable connector
4 keyboard connector
NOTICE: To avoid scratching the palm rest when replacing the keyboard, hook the tabs along the front edge of the keyboard into the palm rest,
and then secure the keyboard in place.