Dell Inspiron 3800 - Manual (Page 55)

6. Tighten the three captive screws on the corners of the shield to secure the microprocessor module and shield.
Display Assembly
Figure 13. Display Assembly
To remove the display assembly, perform the following steps.
NOTICE: To avoid damaging the system board, the power cable, battery, and second battery (if installed)
must be removed before you service the computer.
NOTICE: Do not remove the palmrest before you remove the display.
1. Remove the keyboard assembly .
2. Close the display.
3. Remove the three 4-mm screws, labeled with a "circle D," from the back of the computer (see Figure 13 ).
4. Open the display.
5. Disconnect the liquid crystal display (LCD) flex cable from the connector on the system board by pulling
the connector straight up.
6. Lift the display assembly from the bottom case assembly.
7. Pry the hinge cover loose at the seam from the snap tabs on the bottom assembly (see Figure 13).
Display Assembly Bezel
Figure 14. 14.1-Inch Display Assembly
1 4-mm screws (3)
2 Snap tab
3 Bottom case assembly
4 Snap tab
5 LCD flex cable
6 Hinge cover
7 Display assembly