Dell SP2309WFP Monitor - Manual (Page 21)

OSD Warning Messages
Select Yes to disable DDC/CI or No to return.
LCD Conditioning LCD conditioning helps eliminate any image retention and may take several hours.
NOTE: Severe cases of image retention are known as burn-in. LCD Conditioning does not remove burn-in.
Disable: This is the default option.
Enable: Enables LCD conditioning and the following message appears on the screen. Select Yes to proceed and No to return.
NOTE: Touch any key on the monitor to terminate LCD Conditioning at any time.
Factory Reset Resets all OSD settings to the factory preset values.
Personalize
Allows you to adjust shortcut key key for: 1. Brightness & Contrast, 2. Input Source, and 3. Preset mode.
The following warning messages may appear on the screen to indicate that the monitor is out of synchronization.
This means that the monitor cannot synchronize with the signal that it is receiving from the computer. Either the signal is too high or too low
for the monitor to use. See
Specifications for the Horizontal and Vertical frequency ranges addressable by this monitor. Recommended mode
is 2048 X 1152 at 60Hz.