Dell ST2410 Monitor - Manual (Page 27)

Back to Contents Page
Setting Up the Monitor
Dell™ ST2210/ST2310/ST2410 Flat Panel Monitor User's Guide
Attaching the Base
Connecting the Monitor
Attaching the Soundbar (Optional)
Removing the Base
Attaching the Base
Complete the following steps to attach the base.
1. Place the monitor on a soft cloth or cushion.
2. Attach the base to the monitor.
3. Tighten the screw located below the stand.
Connecting the Monitor
To connect your monitor to the computer perform the following steps/instructions:
1. Turn off your computer and disconnect the power cable.
2. Connect the HDMI cable, white (digital DVI-D), or blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer. Do not use all the cables on the same computer.
Use all of the cables only when they are connected to different computers with appropriate
video systems.
Connecting the blue VGA cable
NOTE: The base is detached when the monitor is shipped from the factory.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions .