Dell OptiPlex GX1p - Manual (Page 33)

see " Getting Help " in your Diagnostics and
Troubleshooting Guide for instructions.
ERROR: Failed to activate device,
CSN=Card Select Number. A Plug and Play expansion card
could not be activated. Use the following procedure:
1. Exit the ICU and turn off your system.
2. Remove the Plug and Play expansion card that
could not be activated.
Follow steps 2 through 6 in "
Removing an
Expansion Card " and then return to this
procedure.
3. Reinstall the Plug and Play expansion card.
Follow steps 5 through 10 in "
Installing an
Expansion Card " and then return to this
procedure.
If you still receive the error message, contact the
manufacturer of the Plug and Play expansion card for
assistance.
WARNING: Could not configure Plug
and Play Card Name.
WARNING: Could not configure PCI
device, ID=DeviceID.
Failed to configure Number of Total
Count Plug and Play ISA devices. Use
your system's configuration utility
to resolve conflicts. Press any key
to continue.
The card(s) mentioned are not
fully configured due to resource
conflicts. If you have documentation that lists the allowable
resource values for your Plug and Play or PCI
expansion card, you can use the following procedure to
locate and resolve the resource conflict.
NOTE: If you do not have documentation listing the
allowable resource values, see the corrective action
for these messages.
1. Start the ICU.
Any Plug and Play or PCI expansion cards that
could not be configured should be marked config
err on the list of cards in the ICU window.
2. Select the System Resources option from the
View menu.
The System Resource Usage dialog box displays
all resources currently used by the system.
3. Select one of the resources used by your Plug
and Play or PCI expansion card, and click Used
By Card.
The Card Resources Usage dialog box identifies
which device is using the resource.
4. Repeat step 3 until you have identified all
conflicting resources and the cards that use them.
5. Modify the cards, as needed, to free the
resources required by the unconfigured Plug and
Play or PCI expansion card.
See "
Modifying a Card " for instructions.
WARNING: Could not configure Plug
and Play Card Name.
WARNING: Could not configure PCI
device, ID=DeviceID.
Failed to configure Number of Total
Count Plug and Play ISA devices. Use
your system's configuration utility
to resolve conflicts. Press any key
to continue.
The card(s) mentioned are not
fully configured due to resource
conflicts. If you do not know the allowable resource values for
your Plug and Play or PCI expansion card, use the
following procedure to locate and resolve the resource
conflict:
1. Remove all card configurations from the ICU.
See "
Removing a Card " for instructions.
2. Reboot your system.
The ICU should automatically configure your Plug
and Play or PCI expansion card.
3. Add the ISA expansion cards back into the ICU,
resolving any resource conflicts as they arise.