Dell OptiPlex GX100 User Manual

Page 46

Advertising

Back to Contents Page

Front-

Panel Inserts: Dell™ OptiPlex™ GX100 System User's Guide

Low-Profile Chassis Front-Panel Inserts

Empty drive bays contain a front-panel insert to protect the inside of the computer from dust particles and also to ensure proper airflow within the
computer. Before you install a drive in an empty drive bay, you must remove the front-panel insert.

To remove the insert covering the 5.25-inch bay, perform the following steps:

1. Turn off the system, including any attached peripherals, and disconnect all the AC power cables from their electrical outlets.

Remove the computer cover

3. Lay the computer cover upside down on a flat work surface, with the front of the cover facing toward you.

4. With your thumbs, press in each end of the insert until it snaps free of the cover (see Figure 1).

Figure 1. Removing the Front-Panel Insert for the 5.25-Inch Bay (Low-Profile Chassis)

To replace the front-panel insert for the 5.25-inch bay, work from inside the cover. Position the insert behind the bay opening, insert the two ring-
tabs (see

Figure 1

) over the posts on the inside of the opening, and firmly press both ends of the insert into place.

To remove the insert covering the 3.5-inch bay, perform the following steps:

1. Complete steps 1 through 3 of the procedure for removing the 5.25-inch insert.

2. Inside the cover, locate the eject button mechanism for the 3.5-inch bay (see

Figure 2

). Press the mechanism toward the front panel to snap

the plastic insert out of its opening.

Figure 2. Removing the Front-Panel Insert for the 3.5-Inch Bay (Low-Profile Chassis)

To replace the front-panel insert for the 3.5-inch bay, work from outside the cover. Place the insert in position and press it into the opening.

Low-Profile Chassis Front-Panel Inserts

Mini Tower Chassis Front-Panel Inserts