System board, Removing the system board – Dell Inspiron 537 (Mid 2009) User Manual
Page 40
Back to Contents Page
System Board
Dell™ Inspiron™ 535/537/545/546 Service Manual
Removing the System Board
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Remove any add-in cards on the system board (see
Removing PCI and PCI Express Cards
).
4.
Remove the processor fan and heat sink assembly (see
Removing the Processor Fan and Heat Sink Assembly
).
5.
Remove the processor (see
Removing the Processor
).
6.
Remove the memory modules (see
Removing Memory
) and document which memory module is removed from each memory socket so that the memory
modules can be installed in the same location after the board is replaced.
7.
Disconnect all cables from the system board. Note the routing of all cables as you remove them so that you can re-route them correctly after installing
the new system board.
8.
Remove the screws from the system board.
9.
Lift the system board up and out.
Inspiron 535/537
Inspiron 545/546
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING:
Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
1 screws (6) 2 system board