Modem – Dell Inspiron 2650 User Manual
Page 79
5.
Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
6.
Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
Modem
1.
Turn the computer over, and remove the memory module/modem cover:
a.
Remove the M2.5 x 5-mm screw from the memory module/modem cover.
b.
Slide the cover out approximately 10 mm, and lift it away from the computer.
2.
If a modem is not already installed, go to
. If you are replacing a modem, remove the existing modem:
a.
Remove the two M2 x 3-mm screws that secure the modem to the system board, and set them aside.
b.
Pull the modem straight up by the pull tab to lift the modem out of its connector, and disconnect the modem cable.
2 memory module/modem
cover
3 arrows (2)
4 lines (2)
CAUTION:
Before performing these procedures, turn off the computer, disconnect it from the electrical outlet, and disconnect the modem from the
telephone wall jack.
NOTICE:
Disconnect any attached devices from electrical outlets, and remove any installed battery.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
Read "
Preparing to Work Inside the Computer
" before performing the following procedure.
1 M2.5 x 5-mm screw
2 memory module/modem
cover