Dell Dimension 8300 User Manual

Page 4

Advertising
background image

 

Back to Contents Page

 

Message

Possible Cause

Corrective Action

8042 Gate-A20 error

The keyboard controller failed its test.

If you receive this message after you make changes in the

system setup

program

, enter the program and restore the original value(s).

Address Line Short!

An error in the address decoding circuitry in the
memory has occurred.

 

Reseat the memory modules

.

C: Drive Error

C: Drive Failure

The hard drive is not working or is not configured
correctly.

Ensure that the drive is installed correctly in the computer and defined
correctly in the

system setup program

.

Cache Memory Bad, Do

Not Enable Cache

The cache memory is not operating.

See "Contacting Dell" in your Owner's Manual for instructions on obtaining
technical assistance.

CH-2 Timer Error

An error is occurring on the timer on the system
board.

See "Contacting Dell" in your Owner's Manual for instructions on obtaining
technical assistance.

CMOS Battery State

Low

CMOS Checksum Failure

CMOS System Options

Not Set

CMOS Display Type

Mismatch

CMOS Memory Size

Mismatch

CMOS Time and Date

Not Set

The system configuration information in the system
setup program is incorrect or the battery charge
may be low.

 

Enter the system setup program

, verify the system configuration, and then

restart the computer.

Diskette Boot Failure

Drive A or B is present but has failed the BIOS POST. Ensure that the drive is installed correctly in the computer and defined

correctly in the

system setup program

. Check the interface cable at both

ends.

DMA Error

DMA 1 Error

DMA 2 Error

Error in the DMA controller on the system board.

The keyboard or

system board

may need to be replaced.

FDD Controller

Failure

HDD Controller

Failure

The BIOS cannot communicate with the floppy drive
or hard drive controller.

Ensure that the

floppy drive

or the

hard drive

is installed correctly in the

computer and defined correctly in the

system setup program

. Check the

interface cable at both ends.

INTR1 Error

INTR2 Error

An interrupt channel on the system board failed to
POST.

The keyboard or

system board

may need to be replaced.

Invalid Boot Diskette

The operating system cannot be located on drive A
or drive C.

 

Enter the system setup program

and confirm that drive A or drive C is

properly identified.

Keyboard Error

The BIOS has detected a stuck key.

Ensure that nothing is resting on the keyboard; if a key appears to be stuck,
carefully pry it up. If the problem persists, you may need to replace the
keyboard.

KB/Interface Error

An error occurred with the keyboard connector.

Ensure that nothing is resting on the keyboard; if a key appears to be stuck,
carefully pry it up. If the problem persists, you may need to replace the
keyboard.

No ROM Basic

The operating system cannot be located on drive A
or drive C.

 

Enter the system setup program

and confirm that drive A or drive C is

properly identified.

Advertising