Camera module, Removing the camera module, Replacing the camera module – Dell Inspiron 15 (1564, Early 2010) User Manual
Page 10
Back to Contents Page
Camera Module
Dell™ Inspiron™ 1564 Service Manual
Removing the Camera Module
1.
Follow the procedures in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the display assembly (see
Removing the Display Assembly
).
4.
Remove the display bezel (see
Removing the Display Bezel
).
5.
Remove the display panel (see
Removing the Display Panel
).
6.
Peel the camera module off the display cover.
7.
Remove the tape that secures the camera cable to the camera module.
8.
Disconnect the camera cable from the camera module.
Replacing the Camera Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
NOTE:
The color of the tape on the camera module may vary depending on your computer model.
1
display cover
2
alignment posts (2)
3
camera module
4
tape
5
camera cable