Dell Inspiron 14z (5423, Mid 2012) - Manual (Page 17)

Replacing the Optical-Drive Assembly | 17
6 Replacing the Optical-Drive Assembly
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 7. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 9. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the tabs on the optical-drive bezel with the slots on the optical drive and snap
it into place.
2 Align the screw holes on the optical-drive bracket with the screw holes on
the optical drive.
3 Replace the screws that secure the optical-drive bracket to the optical drive.
4 Slide the optical-drive assembly into position and ensure that the screw hole on the
optical-drive bracket aligns with the screw hole on computer base.
Postrequisites
1 Follow the instructions from step 3 to step 4 in "Replacing the Memory Module(s)"
on page 13.
2 Follow the instructions in "After Working Inside Your Computer" on page 9.
OM_Book.book Page 17 Tuesday, October 16, 2012 11:59 AM