Canon CP730 - Manual (Page 41)

41
Getting Ready Printing Appendices Overview
Troubleshooting Tasks and Index Next Back
Return to Cover Page
CAUTIONS
WARNINGS
• Do not stick any part of your hand into the printer interior.
• Do not use or store the equipment in the following types of places.
Humid or dusty areas, places subject to heavy vibrations, places near flames, places
subject to strong sunlight, or hot places such as an automobile trunk or dash-
board.
• Do not attach metallic pins or allow dirt to collect on the power plug or
recharging connectors.
• Do not use the compact power adapter beyond its rated capacity or
voltage. In addition, do not leave the power plug partially or inadequately
inserted into a power outlet.
There is a risk of heat generation or explosions.
• Remove the compact power adapter power cord from the power outlet
when not using the equipment.
Leaving it plugged in for long periods of time may pose the risk of heat generation
or deformation.
• Do not remove the paper cassette from the printer while printing is in
progress.
To Prevent Malfunctions and Damage Caused by Electromagnetic Fields
• Never position the equipment close to motors to other devices that
generate strong electromagnetic fields. Moreover, do not use it near
televisions or AM radios.
To Prevent Condensation
• You can avoid condensation by placing the devices in an airtight, resealable
plastic bag and letting them adjust to temperature changes slowly before
removing them from the bag. In the event that condensation does form
within the equipment, keep it at room temperature until the water
droplets evaporate naturally before using it.
Battery (CP730 Only)
• Do not place the battery pack near a heat source or expose it to direct
flame or heat.
• The battery pack should not be immersed in water.
• Do not attempt to disassemble, alter or apply heat to the battery pack.
• Avoid dropping or subjecting the battery pack to severe impacts that could
damage the casing.
• Use only recommended battery pack and accessories.
There is a risk of the battery exploding or rupturing. In the event that a bat-
tery leaks and the eyes, mouth, skin or clothing contact these leaked substances,
immediately flush with water.
• When you are not using the printer, remove the battery and store it
properly.
• Do not place anything, such as tablecloths, carpets, bedding or cushions, on
top of the battery charger while it is charging.
There is a risk of heat generation or deformation if it is left connected for a long
period of time.
• Before you discard a battery, cover the terminals with tape or other
insulators to prevent direct contact with other objects.
Contact with the metallic components of other materials in waste containers may
lead to fire or explosions.