Dell Latitude Xpi - Manual (Page 7)

Dell Latitude XPi CD Service Manual Update 7
LCD Inverter Board
The inverter board assembly with order name SVC,LCD/INVTR,IBM,LXPiCD
(see the “Factory Repair Parts and Assemblies” table found later in this
document) is different from the inverter board assembly with order name
SVC,LCD/INVTR,SMSNG,LXPiCDX.
If the back light on the LCD panel is not working, replace both the inverter
board and the LCD panel.
Bottom Case Assembly Removal
The parts of your computer may be different from the parts shown in Fig-
ure 4-22, “Bottom Case Assembly Removal,” of the Service Manual (Figure 22
of the Parts Removal and Replacement Guide). The superpart docking EMI clip
and superpart serial EMI clip may be smaller. The superpart assembly may also
look different. The upper I/O bracket clip has been renamed the deck buoy.
Diskette/CD-ROM Drive Assembly
There may be a bracket spacer on the diskette/CD-ROM assembly in your
computer.
Deck Buoy
The deck buoy in your computer may have an EMI clip attached to it.
System Board Assembly Removal
The parts of your computer may be different from the parts shown in Fig-
ure 4-27, “System Board Assembly Removal,” of the Service Manual (Figure 27
of the Parts Removal and Replacement Guide). The battery compartment may
have a plastic cover.
Advanced Port Replicator Connector Dust Cover
The callout in Figure 4-31 (Figure 31 of the Parts Removal and Replacement
Guide) refers to the Advanced Port Replicator connector dust cover.
Audio Board
The parts of your computer may be different from the parts shown in
Figure 4-32, “Audio Board Removal,” of the Service Manual (Figure 32 of the
Parts Removal and Replacement Guide). The hard-disk drive bracket and the
audio board may have a shield, a clip, an insulator, and standoffs added.
F
actory Repair Parts Changes
Removal and replacement procedures for all factory components and subassem-
blies are the same as those described in Appendix A, “Factory Repair Parts,” of