Installing the card reader, Removing the power supply unit (psu) – Dell Vostro 270 (Late 2012) User Manual
Page 17
Installing the Card Reader
1.
Slide the multimedia-card reader in through the front of the computer.
2.
Replace the screws that secure the multimedia-card reader to the drive cage.
3.
Route the cable thorough the metal clip(s), if present, to secure the cable along the inside of the computer.
4.
Connect the multimedia-card reader cable to the system board.
5.
Replace the:
a) front panel
b) cover
6.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Supply Unit (PSU)
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the cover.
3.
Disconnect the power-supply cables connected to the hard drive (s), optical drive (s), and system board.
4.
Remove the screws that secure the power-supply unit to the back of the computer.
5.
Press the release button located on the floor of the system chassis, and then slide the power-supply unit toward
the front of the computer.
17