Installing the system board – Dell PowerEdge 1800 User Manual
Page 8
Installing the System Board
1.
Holding the system-board tray at an angle, slide the front end of the tray into the chassis. See
The front end of the tray has the system-board tray handle attached to it.
2.
Lower the back end of the system-board tray until it lays flat in the chassis.
3.
Use the system-board tray handle to slide the tray towards the back of the chassis until it stops.
4.
Tighten the system-board retainer thumbscrew located on the back panel. See
.
5.
Replace the drive cage.
6.
Replace the heatsink(s) and microprocessor(s).
7.
Replace the memory modules.
8.
Reconnect all cables to the system board.
9.
Replace the expansion-card guide and the front fan.
10.
Replace the expansion cards.
11.
Replace the baffle/back fan assembly.
12.
Close the system.
13.
Reinstall the bezel.
Back to Contents Page