Dell Precision M2400 (Mid 2008) User Manual
Replacing the bottom access panel, About cautions
Replacing the Bottom Access Panel
A CAUTION indicates a potential for property damage, personal injury,
Before you begin any of the procedures in this section, read the safety
information that shipped with your computer. For additional safety best practices
information, see the Regulatory Compliance Homepage at
If you need to remove the computer cover, first disconnect the computer
power and modem cables from all electrical outlets.
To replace the bottom access panel of your computer, you need the
iAMT configuration-mode number that is located on the original bottom
access-panel of your computer.
Follow the instructions on this tech sheet carefully to ensure that you:
Remove the original bottom access-panel from your computer (see your
Select the correct label that is provided in the replacement kit.
Install the label in the correct location on the replacement bottom
To replace the bottom access panel:
1 Remove the original bottom access-panel from your computer (see your
If the original iAMT configuration-mode label is missing, damaged,
or otherwise illegible, contact Dell to obtain your iAMT configuration-mode
number (see your Setup and Quick Reference Guide for contact information).
T539H0am0-edited.fm Page 1 Tuesday, November 3, 2009 4:57 PM