Craftsman HIGHSPEED SWEEPER 486.24229 User Manual

Page 8

Advertising
background image

8

Call 1-866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE

sTep 13:

(see FigUre 13)

Secure the top and bottom hopper tubes together

1.

using two 5/16" x 3/4" hex bolts (17) on inside and
two 5/16" nylock nuts (21) outside.

sTep 14:

(see FigUre 14)

Install two cotter pins (27) in the rear hopper tube.

•

Bend ends of cotter pins around tube.
Slide the dump handle clip (33) onto the dump handle.

•

Attach the dump tube to the rear hopper tube using a

•

U-clamp (34) placed between the cotter pins, a 1/4" x
1-1/2" hex bolt (16) and a 1/4" nylock nut (24).
Swivel the dump tube so that the end of the tube

•

rests on the ground behind the bag and supports the
rear of the bag in an upright position.

sTep 15:

(see FigUre 15)

Insert the hopper support rods (7) into the hole

•

beneath the curved head bolt (26) in each upper
hopper tube. Flex and insert the rod into the hole in
the bottom rear hopper tubes as shown.

NOTe: The hopper support rods will flex about as much
as shown in figure 15 when they are assembled.

sTep 16:

(see FigUre 16)

Slide the pivot rod (2) through the flap in the bag's

•

windscreen first and then through the hole in each
upper hopper tube.
Hammer a palnut (23) onto each end of the pivot rod .

•
HiNT: Place the bag on its side on a hard surface to
make installation of palnuts easier.

FigUre 13

17

17

21

21

FigUre 14

24

27

16

34

5

33

FigUre 15

7

7

26

7

FigUre 16

2

23

Advertising