Driver installation, Led status indicator light – Dell External USB NTSC/ATSC TV Tuner User Manual
Page 8
3. Connecting a cable box or satellite receiver (set-top box)
a.
Connect either a composite video cable or an S-video cable (1 - cables not included) from the cable TV box or satellite receiver (3) to the Video or S-
Video connector on the front panel of the Dell External USB NTSC/ATSC TV Tuner (4).
b.
Connect the audio cables (2 - cables not included) from the cable TV box or satellite receiver (3) to the Audio Left and Audio Right connectors on the
front panel of the Dell External USB NTSC/ATSC TV Tuner (4).
If you have a second TV signal input source and a second Dell External USB NTSC/ATSC TV Tuner, repeat the hardware installation steps using the connectors
on the second Dell External USB NTSC/ATSC TV Tuner.
Driver Installation
If the driver and the hardware are not installed or if you need to reinstall them, perform the following steps:
1.
With Windows® running on your computer, insert the Dell Resource CD into your CD/DVD drive.
2.
If the Dell Resource CD window does not open automatically, double click on My Computer on your desktop and then double click on the CD/DVD drive
containing the Dell Resource CD.
3.
Follow the instructions provided by the Dell Resource CD to locate the video driver package for your Dell External USB NTSC/ATSC TV Tuner card.
4.
Once you have located the package, select the Lumanate setup.exe to unzip the drivers on to the hard drive and install the drivers.
5.
At the Setup Complete screen, select Yes and click Finish to restart your system.
LED Status Indicator Light
LED is on and does not blink:
1.
The hardware driver is installed.
2.
The Dell External USB NTSC/ATSC TV Tuner is powered, and is ready to use.
LED is on and is blinking:
1.
The hardware driver might not be installed.
2.
The hardware driver may be corrupted.
3.
The Dell External USB NTSC/ATSC TV Tuner is powered, but the computer is in standby mode.
4.
The Dell External USB NTSC/ATSCTV Tuner, but is connected to a USB 1.0 or 1.1 port.
LED is off:
Note: Observe the green indicator light (LED) on the front panel of the Dell External USB NTSC/ATSC TV Tuner. The LED will aid in determining the
current status of the device.