Dell PowerEdge 7250 - Manual (Page 2)

www
.de
ll
.co
m |
sup
por
t.d
e
ll
.c
om
2 Open the module to the appropriate side for the processors that you are replacing.
• For processor 1 or 3, see "Processor/Memory Module Primary Side Access" and "Primary
Side Component Location" in the Product Guide.
• For processor 2 or 4, see "Processor/Memory Module Primary Side Access" and "Primary
Side Component Location" in the Product Guide.
3 Remove any dual in-line memory modules (DIMMs) that block removal of the processors.
See "Removing and Installing DIMMs" in the Product Guide.
4 Remove the power pods associated with the processors that you are removing. See "Removing
a Power Pod" in the Product Guide.
5 Remove the processors or thermal blanks to be replaced. See "Handling the Intel Itanium 2
Processors," "Removing a Processor," and "Removing a Thermal Blank " in the Product Guide.
6 Install the new processors. See "Handling the Intel Itanium 2 Processors" and "Installing a
Processor" in the Product Guide.
7 Install the power pods. See "Installing a Power Pod" in the Product Guide.
8 Replace any DIMMs that you removed in step 2. See "Removing and Installing DIMMs" in
the Product Guide.
9 Close the processor/memory module. See "Processor/Memory Module Primary Side Access" or
"Processor/Memory Module Secondary Side Access" in the Product Guide, as explained in
step 2.
10 Replace the processor/memory module.
Rebooting Your System
1 Reconnect the AC power cords and press the power button. A full beep indicates that the
system is reading the CD .
2 Wait two minutes; two beeps sound to indicate that the BIOS recovery has been successfully
completed. The system automatically reboots.
3 Remove the CD.
4 After the system reboots, press <F2> to enter the BIOS setup.
5 Verify that the BIOS version number in the Main Menu matches the one that you wrote down
in step 1 of "Updating the BIOS."
6 Restore any BIOS setup and Boot Manager settings documented in "Updating the BIOS."