System board, Removing the system board – Dell Inspiron 710M User Manual
Page 32
Back to Contents Page
System Board
Dell™ Inspiron™ 700m/710m Service Manual
Removing the System Board
1.
Remove the
battery
.
2.
Remove the
module bay device
.
3.
Remove the
hard drive
.
4.
Remove the
Mini PCI card
, if present.
5.
Remove the
modem card
, if present.
6.
Remove the
keyboard
.
7.
Remove the
upper memory module
.
8.
Remove the
memory module
.
9.
Remove the
display module
.
10.
Remove the
palm rest
.
11.
Remove the two 5 mm hex nuts on either side of the video connector located on the left side of the computer.
12.
Disconnect the coin-cell battery connector and the modem cable connector from the main board.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE:
Disconnect the computer and any attached devices from electrical outlets.
NOTICE:
To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
Read "
Before Working Inside Your Computer
" before performing the following procedure.
1 hex screws (2)
4 system board
2 coin-cell battery connector
5 modem cable connector
3 upper case M2 x 5-mm screw