Dell Dimension 3100C - Manual (Page 13)

1. Follow the procedures in " Before You Begin ."
2. Press out the securing clip at each end of the memory module connector.
3. Align the notch on the bottom of the module with the crossbar in the connector.
4. Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.
5. Replace the computer cover .
6. Connect your computer and devices to electrical outlets, and turn them on.
7. When a message appears stating that memory size has changed, press <F1> to continue.
8. Log on to your computer.
9. Right-click the My Computer icon and click Properties.
10. Click the General tab.
11. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
1 memory connector closer to processor 2 securing clips (2) 3 connector
1 cutouts (2) 2 memory module 3 notch
4 crossbar
NOTICE: To avoid damage to the memory module, press the module straight down into the connector while applying equal force to each end of the
module.
NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.