Dell U2312HM Monitor User Manual
Page 30
Simplified Chinese or Japanese).
Menu Transparency
Select this option to change the menu transparency by pressing
and
buttons (Minimum: 0 ~ Maximum: 100).
Menu Timer
OSD Hold Time: Sets the length of time the OSD will remain active after the last time you pressed a button.
Use the
or
to adjust the slider in 1 second increments, from 5 to 60 seconds.
Menu Lock
Controls user access to adjustments. When Lock is selected, no user adjustments are allowed. All buttons are locked.
NOTE:
Lock function – Either soft lock (through OSD menu) or hard lock (Press and hold the button above power button for 10 sec)
Unlock function– Only hard unlock (Press and hold the button above power button for 10 sec)
Menu Rotation
Rotates the OSD by 90 degrees counter-clockwise. You can adjust the menu according to your
Energy Smart
When Energy Smart is switched On, the Brightness function shall be disabled.
When the Energy Smart is Off, Brightness function shall be activated.
The text and the icon of “Dynamic Contrast” shall be deactivated and grey out.
When Energy Smart is On, monitor will adjust brightness dynamically according to the screen content for saving power
consumption.
When Energy Smart is On, The 'Energy Use indicator' on OSD menu should response to the changes in the screen content.
Power Save Audio
To turn on or off Audio Power during Power Save mode.
DDC/CI /
DDC/CI (Display Data Channel/Command Interface) allows your monitor parameters (brightness, color balance etc) to be adjustable via
software on your computer. You can disable this feature by selecting "Disable".
Enable this feature for best user experience and optimum performance of your monitor.
LCD Conditioning
Helps reduce minor cases of image retention. Depending on the degree of image retention, the program may take some time to run. You
can enable this feature by selecting "Enable".
Factory Reset
Reset all OSD settings to the factory preset values.
Personalize
User can select from "Preset Modes", "Brightness/Contrast", "Auto Adjust", "Input Source" and set as shortcut key.