Installing the input/output panel, Removing the system board – Dell OptiPlex 9010 (Mid 2012) User Manual
Page 32
Advertising
7.
Slide the I/O panel towards the left of the computer to release it and pull the I/O panel along with its cable out of the
computer.
Installing the Input/Output Panel
1.
Insert the I/O panel into the slot on the chassis front.
2.
Slide the I/O panel towards the right of the computer to secure to the chassis.
3.
Use a Phillips screwdriver to tighten the single screw securing the I/O panel to the chassis.
4.
Thread the I/O panel and FlyWire cables into the chassis clip.
5.
Connect the I/O panel and FlyWire cables to the system board.
6.
Install the front panel.
7.
Install the cover.
8.
Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a. cover
32
Advertising