Expansion-card cage, Riser boards – Dell OptiPlex GX110 User Manual
Page 10
3. Remove the screw below the fan guard on the back of the chassis.
4. Slide the power supply toward the front of the computer approximately 1 inch.
5.
Lift the power supply up and out of the chassis.
Expansion-Card Cage
Figure 14. Expansion-Card Cage Removal
To remove the expansion-card cage, perform the following steps:
1. Examine any cables connected to expansion cards through the back-panel openings and disconnect any cables that will not reach to where
the cage must be placed upon removal from the chassis.
2.
Locate the securing lever (see Figure 14). Rotate the lever upward until it stops in an upright position.
3. Slide the expansion-card cage out of the chassis.
4. Lift the expansion-card cage up and away from the chassis.
To replace the expansion-card cage into the low-profile chassis, perform the following steps:
1. With the securing lever in the upright position, align the expansion-card cage slots with the tabs in the chassis opening for the expansion-
card cage (see Figure 14). Slide the expansion-card cage into place.
2. Rotate the securing lever downward until it is flush with the top of the chassis. Make sure that the riser board is fully seated in the RISER
connector on the system board.
3. Reconnect any cables you removed in
of the previous procedure.
Riser Board
The low-profile chassis has a PCI riser board (see Figure 15). The PCI riser board provides three PCI expansion-card slots.
Figure 15. PCI Riser Board
To remove the riser board, perform the following steps.
1 Securing lever
2 Expansion-card cage
3 Slots (2)
4 Tabs (2)
NOTICE: Use a wrist grounding strap as explained in "
1 Auxiliary power indicator LED (AUX_LED)
2 Wakeup On LAN (WOL) connector
3 PCI expansion slot 1 (PCI1)
4 PCI expansion slot 2 (PCI2)
5 PCI expansion slot 3 (PCI3)