Dell 4610X Wireless Projector - Manual (Page 46)

46 Using Your Projector
A
UDIO
S
ETTINGS
— Select and press to change audio settings. The audio
settings menu consists of the following options:
A
UDIO
I
NPUT
— Select the Audio input source, options are: Audio-A, Audio-
B, Audio-C, and HDMI.
V
OLUME
— Press to decrease the volume and to increase the volume.
S
PEAKER
— Select On to enable speaker. Select Off to disable speaker.
M
UTE
— Allows you to mute the sounds for audio input and audio output.
P
OWER
S
ETTINGS
— Select and press to activate power settings. The power
settings menu consists of the following options:
P
OWER
S
AVING
— Select Off to disable Power Saving mode. By default, the
projector is set to enter power saving mode after 120 minutes of no activity.
A warning message appears on screen showing a 60-second countdown
before switching to power saving mode. Press any key buttons during
countdown period to stop power saving mode.
You can also set a different delay period to enter power saving mode. The
delay period is the time you want the projector to wait without an input
signal. Power saving can be set to 30, 60, 90, or 120 minutes.
If an input signal is not detected during the delay period, the projector
turns off the lamp and goes into power saving mode. If an input signal is
detected within the delay period, the projector automatically turns on. If
an input signal is not detected within two hours during power saving mode,
the projector switches from Power Saving mode to Power Off mode. To
turn on the projector press the Power button.