Dell PowerEdge T610 - Manual (Page 6)

6 Tower-to-Rack Conversion Guide
Rotating the LCD Display Module
1 Remove the optical drive from the top (or left) drive bay of the system.
a Disconnect the power and data cables from the back of the optical
drive. See Figure 1-1.
b Slide the drive release latch in the direction of the arrow to release the
drive.
c Slide the drive out to remove it from the drive bay.
2 Rotate the LCD display module 90 degrees clockwise to the horizontal
rack orientation.
3 Reinstall the optical drive in the system.
a Align the shoulder screws on the optical drive with the drive bay screw
slots.
b Insert the optical drive into the drive bay until the release latch locks
into place.
c Reconnect the power and data cables to the back of the optical drive.
4 Close the system cover.
Installing the Rack Ears
1 Align the rack ear screw holes with the screw holes on the right side of the
system chassis. See Figure 1-2.
2 Install the three screws using a #2 Phillips screwdriver.
3 Repeat for the left rack ear piece.
Installing the Bezel
1 Insert the tabs at the bottom of the bezel into the tab slots at the bottom
of the chassis.
2 Firmly press the top of the bezel into the chassis until the lever locks into
place.
3 Using the system key, lock the bezel.
Rack Installation
See the system’s Rack Installation Guide for the proper procedure for
installing the system in a rack.