Dell Vostro 15 (3546, Mid 2014) - Manual (Page 19)

Installing the Palmrest Assembly
1. Place the palmrest on the chassis and press the notches until it clicks in place.
2. Connect the touchpad and power cables to the system board.
3. Tighten the screws to secure it to the system board.
4. Turn the computer over and tighten the screws at the base of the computer.
5. Install:
a. keyboard
b. memory module
c. hard drive
d. WLAN
e. access panel
f. optical disk-drive
g. battery
6. Follow the procedures in After Working Inside Your computer .
Removing the Battery Connector
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a. battery
b. optical disk-drive
c. access panel
d. hard drive
e. memory module
f. keyboard
g. palmrest assembly
3. Perform the following steps as shown in the illustration:
19