Dell POWEREDGE 1855 - Manual (Page 21)

Back to Contents Page
Using the System Setup Program
Dell™ PowerEdge™ 1855 Systems User's Guide
Entering the System Setup Program
System Setup Options
System and Setup Password Features
Disabling a Forgotten Password
Acquiring the asset.com Utility
Baseboard Management Controller
After you set up your system, run the System Setup program to familiarize yourself with your system configuration and optional settings. Record the
information for future reference.
You can use the System Setup program to:
l Change the system configuration stored in NVRAM after you add, change, or remove hardware
l Set or change user-selectable options—for example, the time or date
l Enable or disable integrated devices
l Correct discrepancies between the installed hardware and configuration settings
Entering the System Setup Program
1. Turn on or restart your system.
2. Press <F2> immediately after you see the following message:
<F2> = Setup
If your operating system begins to load before you press <F2>, allow the system to finish booting, and then restart your system and try again.
Responding to Error Messages
You can enter the System Setup program by responding to certain error messages. If an error message appears while the system is booting, make a note of
the message. Before entering the System Setup program, see "System Beep Codes" and "System Messages" in your Installation and Troubleshooting Guide for
an explanation of the message and suggestions for correcting errors.
Using the System Setup Program
Table 2 -1 lists the keys that you use to view or change information on the System Setup program screens and to exit the program.
Table 2-1. System Setup Program Navigation Keys
System Setup Options
NOTE: When a server module is inserted into a chassis, the server module functions as a system. Each server module has a System Setup program to
allow configuration of the server module and features such as password protection.
NOTE: To ensure an orderly system shutdown, see the documentation that accompanied your operating system.
NOTE: After installing a memory upgrade, it is normal for your system to send a message the first time you start your system.
Keys Action
Up arrow or <Shift><Tab> Moves to the previous field.
Down arrow or <Tab> Moves to the next field.
Spacebar, <+>, <–>, left and right arrows Cycles through the settings in a field. In some fields, you can also type the appropriate value.
<Esc> Exits the System Setup program and restarts the system if any changes were made.
<F1> Displays the System Setup program's help file.
NOTE: For most of the options, any changes that you make are recorded but do not take effect until you restart the system.