2 installation and basic operation, 1 unpacking the pass through module, 2 insertion and removal of the ptm – Dell POWEREDGE M1000E User Manual
Page 8: 1 ptm insertion, Chapter 2 installation and basic operation, Unpacking the pass through module, Insertion and removal of the ptm, 2installation and basic operation
Installation and Basic Operation
Rev 1.0
8
2
Installation and Basic Operation
2.1
Unpacking the Pass Through Module
Before you install your new PTM, unpack it and make sure that there is no visible damage that
may have occurred during shipping. Your package should contain the following items:
• Dell 10Gb Ethernet Pass Through -k module for Blade Servers
• This Users Manual
The PTM is shipped without optical modules.
If anything in the package is damaged or missing, please contact your customer representative
immediately.
2.2
Insertion and Removal of the PTM
The Dell 10Gb Ethernet Pass Through -k module may be plugged into fabric slots A1, A2, B1, B2,
C1, and C2.
Determine which slot to use, based on desired system configuration.
2.2.1 PTM Insertion
Insert the PTM into the chassis as shown in the following diagram:
Figure 3: Dell Chassis Slots for the PTM
Slot A1
Slot B1
Slot C1
Slot A2
Slot B2
Slot C2